Software – 3D Tech Works

Using the Probe Function to Zero your Axes

March 6, 2020 by Darrell Norquay

G-code has a built in function to use a metallic probe contact to zero out the Z axis on the top of your workpiece. This function can also be used to zero out the X and Y axes as well, if you have the correct device. The probe cycle is initiated by a specific g-code … Read more

Programming GRBL into an Arduino

March 24, 2021May 18, 2019 by Darrell Norquay

If you find yourself with a dead Arduino Grbl controller, or you are building a system from scratch, it is useful to know how to program the GRBL firmware into the device. This consists of a few simple steps. Note that these steps refer to a Windows 7 based computer, Windows 8 and 10 are … Read more